SKCC - Southern Kit Car Club. A Club for kit car owners across Southern England. Kent, Sussex, East Hants, Surrey, Berks, Middlesex, London

Hope you join me as i carry out the repairs and paint on someone elses damaged nosecone, in a bid to help others who might want to have a go at the same or similar.
This is only my personal view on the subject and sure others will have their own way of doing things, but it just a means to an end.
link to short introduction video below.

https://youtu.be/dFcR5FQw2K8

richard

We all hope not to need this knowledge, but minor things do happen, and a new nose cone isn't cheap. Thanks

Been trying to upload the 2nd part of this for the last two days given I thought I could load up to 20 min video.
After I got bored waiting I decide to split it in two so here is the next part.

https://youtu.be/0c3Pv7d_qpc

Part 3 now uploaded, carry on reinforcing the inside edges and then preparing the outer surfaces.

https://youtu.be/AQWSXLcdW8g

It's looking good !!

Video 4 is below, fibreglass on some of the outside edges, clean up and start to apply filler.

https://youtu.be/3y5qaKp-j0g

Part 5 sanding the filler and start to apply a spray filler primer.
https://youtu.be/nWexSi8JBsQ

Part 6 is up
https://youtu.be/_E4dJNuTQd8
Starting to rub down some of the spray filler primer and more fibreglass repairs

Next section I hopefully finish the repairs and carry on with spray filler primer.

https://youtu.be/JyF9Yzu0qJM

next step was to start on the satin black

https://youtu.be/6BHjEfJe6B4