Re: WANTED: ST170 inlet manifold base
Posted: Thu May 21, 2020 7:53 am
@ Steve: It's not skill it's persistence.
@DJ Re blowing holes: you should see the injector mounts, not my best work but functional.
Most of it was made in 5 mm which it's a lot easier than anything thinner. I tend to give it a lot of power and as soon as the puddle forms drop the power right down and add filler (the filler helps cools the weld)
@DJ Re blowing holes: you should see the injector mounts, not my best work but functional.
Most of it was made in 5 mm which it's a lot easier than anything thinner. I tend to give it a lot of power and as soon as the puddle forms drop the power right down and add filler (the filler helps cools the weld)