B D Engineering - Carb setup.

Feel free to add your recommends: Please put a general description of the service in the Title.

Moderator: Contaminated

User avatar
Alex.
Posts: 117
Joined: Tue Apr 03, 2018 1:11 pm
Location: Medway
Contact:

B D Engineering - Carb setup.

Postby Alex. » Tue Jun 12, 2018 11:53 am

I put my Tiger back together after a 9 year layover in a garage, including rebuilding the engine and she just did not run very smoothly, or idle much.

So off to B D Engineering in Newington I went. Andy had previously ran a couple of my cars on his dyno, which diagnosed issues, but I went primarily for his expertise in setting up Webers.
After an hour and a half, my car now idles smoothly and reliably at less than 1k revs, gone is the popping and banging at low throttle openings and general misbehaviour! The carbs are perfectly setup, by a combination of Andy's knowledge of how to setup and the use of his dyno.
Additionally, I now know that she started off at only 107bhp and ended up with 152bhp at 6,200rpm and still pulling!

So if you need any setup, diagnostic or dyno work, give BD a shout.

Alex.

P.S. No ties with the garage, no family connection, no discount given (or asked for), just a happy customer.

greenwoo
Site Admin
Posts: 10185
Joined: Thu Dec 03, 2009 10:34 am
Contact:

Re: B D Engineering - Carb setup.

Postby greenwoo » Tue Jun 12, 2018 11:54 am

good to hear, i know a few folks that use them.....

User avatar
SteveRST
Posts: 1261
Joined: Sat Aug 18, 2012 12:23 pm
Location: Chessington
Contact:

Re: B D Engineering - Carb setup.

Postby SteveRST » Tue Jun 12, 2018 1:51 pm

Nice one! That sounds like a pretty healthy Pinto.
Westfield Zetec turbo & Westfield Megabusa turbo

User avatar
Alex.
Posts: 117
Joined: Tue Apr 03, 2018 1:11 pm
Location: Medway
Contact:

Re: B D Engineering - Carb setup.

Postby Alex. » Tue Jun 12, 2018 2:52 pm

SteveRST wrote:Nice one! That sounds like a pretty healthy Pinto.


He did say that he would be surprised if it was just a cam and carbs, there must be something else done too. I'll just drive and enjoy!

Alex.


Return to “Suppliers that you'd recommend to other Members”

Who is online

Users browsing this forum: No registered users and 4 guests